Excess will flow into the gaps between your floor boards Back to top How do I know if I have enough floor left to sand? Not Helpful 7 Helpful 9. Prior to the 20th Century hardwood floors were refinished by scraping. First of all, measure the room—it's much easier to estimate abrasive and finish needs if you know your square footage. Your ad says you have "professional grade abrasives;" what does that mean?
These are, by stain type: However, this process will work only if the floor does not contain any wax residue remember that many floors were routinely waxed in the '50s and '60s, sometimes even when they didn't need wax. Back to top Why do I have to do the floor in two sections? Contractors will often use glue to fasten the foam or felt under the carpet to the floor. This entry was posted on February 27, by Jonathan Sapir. In a living room or bedroom, a wooden floor can be enhanced with rugs and kilims for added warmth and colour. You should sand in the direction of the grain of the wood.
How to Strip Varnish Off a Wood Floor | Home Guides | SF Gate
For heat, use a heat gun or an iron. No data is shared with Facebook unless you engage with this feature. Solid wood flooring is milled from a single piece of timber that is kiln or air dried before sawing. Don't be timid about applying too much of it. You want this debris cleared away before you attack the old wood finish. Of course, you'll also have to determine what type of wood you are replacing to get the right match. This process works with great results as long as the floor hasn't had any waxes or synthetic cleaners.
No matter what you do, there will still be a layer of fine dust on horizontal surfaces and an even finer layer sticking to your walls. How will I know when to change the abrasive? However, it is always best to try to sand out a stain before resorting to more drastic measures; occasionally they do sand out. What do I need to do to get my floors ready to sand? Back to top We just bought a house and took out the carpet and the floors look really good—can we just buff them up a little?